XTOOL MQB V-A-G Access Online Programming 1 Token Suit for Xtool X100 Pad / Pad2 / Pad2 Pro / X100 Pad3

1. This is for Online MQB code, after ordered, contact us to get one code.
2. No shipping, Online sending
3.NO EEPROM REQUIRED!
4. A single access code will connect your Xtool X100 Pad/X100 Pad2/Pad2 Pro/Xtool Pad3 to VAG servers and perform a calculation that will enable OBD2 access for your vehicle internet connection is required. Once the calculation is performed, your device will have unlimited access to that same vehicle.

How to use Xtool VAG Token
Step 1: Select “the vehicle system”:
Different vehicle system interfaces are shown as below:
VW 4th Immobilizer System

Audi 5th Immobilizer System


Audi MQB Platform

Step 2: Select “Online mode”

Step 3: Then you will receive an order information “This password needs to be paid to get it, please contact your local dealer or Xtool”.
Please enter your activation code at this time.

Step 4: Once you input the valid code, it starts getting “Calculation Request Number…”. It will take 30 seconds to 3 minutes in whole process, please be patient!

Step 5: When the calculation process is done, you will get a message “Get data successfully!”

Please kindly notice:
If your internet was interrupted during the online calculation, you will receive an error report “Error code: E40303 Failed to get valid immobilizer information, please connect the our for help

Don’t worry about this problem, your VAG Point Code is still available to use if the calculation fails. Just try to start the calculation using the same code again.
Step 6: Finally, you can add a key or do all keys lost for VAG 4th / 5th IMMO & MQB Immobilizer system.

XTOOL MQB Online Programming V-A-G Access Token Card FAQ

Q: Will it support my golf 7 2013?
A: Yes! sure

Q:Will it support Jetta 2017 MQB 1?
A: Yes!